external heating

英 [ɪkˈstɜːnl ˈhiːtɪŋ] 美 [ɪkˈstɜːrnl ˈhiːtɪŋ]

网络  外热法; 外部加热

化学



双语例句

  1. Retrieve unconditionally the latest temperature and humidity sensor readings and, during the winter season, activate external ventilation or heating based on the following conditions
    无条件地获得最新温度和湿度传感器读数,在冬季,基于以下条件激活外部通风或供热
  2. Shade all external openings in regions where no winter heating is required.
    冬季不需要取暖的地方用遮阳设备遮挡全部的外开口部分。
  3. From the overall look of heating and power generation, External heating unit can save a lot of fuel and improve power plant heat economy.
    从供热和发电的整体看,机组供热能够大量节约燃料,提高电厂热经济性。
  4. Specific heat depends not only on the material in question but also on the external conditions of its heating.
    比热容不仅取决于所研究的物质,而且依赖于加热的外部条件。
  5. A heat regenerative adsorption dryer according to the heating mode can be divided into internal heating and external heating type adsorption dryer adsorption dryer.
    有热再生吸附式干燥机根据加热方式又可分为内加热型吸附式干燥机和外加热型吸附式干燥机。
  6. In the case of Non-metallic pipe, a coat of aluminum tape should be used between external wall of pipes and heating cable to expand heat transfer area.
    非金属管道应在管外壁与伴热电缆之间贴一层铝胶带,用来增大接触传热面积。
  7. Four methods in changing the structure of water clusters are outlined, including external electric field, external magnetic field, laser radiation and heating methods. The mechanism of these four methods are also explained in detail.
    总结了改变水分子团簇结构的四种方法,包括外加磁场、外加电场、激光辐射以及直接加热法,分别讨论了这四种方法的作用机理;
  8. Chemical Cleaning Technology for External Surface of Heating Furnace Piping at Convective Section
    加热炉对流段炉管外表面化学清洗技术
  9. Temperature Test and Analysis of External Pipe-wall of Heating Surface in High Temperature Part of Boiler
    锅炉高温受热面炉外管壁温度检测与分析
  10. Heat Transfer Characteristics of Ilmenite Fine-particles in an Aerated Vibro-fluidized Beds with Horizontal Heating Tubes Horizontal external heating vacuum furnace
    振动流化床中微细粒级钛精矿的传热特性卧式外加热真空炉
  11. A way of external heating and hot conduct was always used in traditional tyre vulcanization, the way had some shortcoming of big temperature gradient and slow heating rate, and effected on the tyre vulcanization quality.
    传统的轮胎硫化工艺一直沿用着外加热及热传导方式进行,这种加热方式存在着温度梯度大、加热速率慢等问题,致使轮胎质量受到一定影响。
  12. This paper presented a new strengthen method of RC short column, in which the four external steel plate was prestressed by heating before welded together on the four side of RC column to form a prestressed steel plate hoop and then made the core concrete to be confined.
    本文结合国内外包钢加固方面的研究成果与实践经验,提出利用温度对钢板箍施加预应力以提高RC短柱抗震加固效果的方法。
  13. Features and Applications of the Oil and Gas External Heating Rotary Kilns
    外热式燃油/燃气回转窑的特点与应用
  14. Determination of d/ h values of oh-bearing minerals by the sample melting method of external heating and flux
    外加热及助熔剂熔样法测定含水矿物的D/H比值
  15. Authors introduce external insulation construction technology in external wall and low temperature floor radiate heating construction technology in Baoji.
    介绍了宝鸡市专威特外墙外保温技术与低温地板辐射采暖技术的施工工艺。
  16. A new method is raised here, the coal combustion smoke is free molecule liquid or continuous liquid to the small particles. We get the calculation expression with physical parameters of pulverized-coal cloud and external heating conditions.
    本文从烟气相对于小煤粉粒子为自由分子流或连续流中提出了一种新的计算方法,结合煤粉群物性参数以及外部加热条件得到计算表达式。
  17. Numerical analysis is made for the unsteady and steady, two-dimensional laminar natural convection in an enclosure caused simultaneously by the external heating and a local internal heat source.
    本文描述由一个局部内热源和外部加热同时作用引起的封闭空腔内非稳态、二维、层流自然对流换热的数值分析结果。
  18. The calculation of annual fuel consumption and annual CO_2 and SO_2 emission converted from annual heat consumption per unit area of external wall in heating period is introduced.
    介绍了供暖期单位面积外墙年耗热量折合成的年燃料耗量及年CO2、SO2排放量的计算。
  19. First in history, the external hot gas generators were used for the furnace heating of a CFB boiler in such a large capacity, and its pros and cons are presented in comparison with other typical furnace-heating methods.
    在具有床下点火预燃室的大型循环流化床锅炉上首次采用了外置热烟气发生器烘炉的方法,并对几种烘炉方法进行了比较分析,比较总结了各种典型的烘炉方法。
  20. Study on Polyethylene Pyrolysis in Continuous-Feeding External-heating Rotary Kiln
    聚乙烯在连续给料外热式回转窑内的热解研究
  21. An internal heating type was adopted Which saves 30% energy in comparison with the external heating type.
    用该催化板组装的反应器可采用内加热形式,和一般的外加热反应器相比可节约能耗约30%。
  22. The temperature state of shape memory alloy ( SMA) wires embedded in composites is uncertain due to variation of the ambient temperature, heat convection, heat radiation and external current inputted for heating.
    由于环境温度、热对流和热辐射条件以及输入的加热电流强度的不同,致使嵌在复合材料中的形状记忆合金的温度难以确定。
  23. The paper describes in details the temperature and vacuum measuring-control system of external heating vacuum furnace.
    分析了外热式真空炉的温度测量控制系统及真空测量控制系统。
  24. Suitable water content was the foundation for producing the high pression vapor in the grains, the external force for the producing the vapor was heating temperature.
    适宜的水分含量是籽粒内部产生高压水汽的物质基础,而导致这种高压水汽产生的外部动力则是来自于加热温度。
  25. Horizontal external heating vacuum furnace Hot Blast Furnace With Heat Pipes
    卧式外加热真空炉
  26. A lot of factors ( aspect ratio, external constraint strength, heating rate, quantity of explosive charge) which have an influence on thermal response characteristics were simulated.
    同时,模拟计算了试样长径比、外约束强度、升温速率、炸药装药量等因素对试样热响应的影响,得出了一系列降低试样热烤易损性的措施。
  27. Therefore, the carbonization furnace with external heating is designed, and it has the advantages of fast carbonization, avoid of burning loss and autothermal process.
    为此,本项目研究自行设计了外热式快速炭化炉,具有快速炭化、炭化过程中避免半焦烧损、过程自热的优点。
  28. Common external thermal fluid heating, electric heating and other methods have some disadvantages, such as different levels of energy consumption, production costs are high, oil underground is complicated, and poor economic.
    常用的外部热流体伴热、电加热等方法都不同程度的存在能耗大、生产成本高、采油井下作业复杂、经济效益差等缺点。
  29. The billet defects in internal and external are more oxidation in the high temperature heating furnace, cause oxidative tissue, which can cause decarburization, rolling section of the serious the non-uniform deformation.
    钢坯的内外部缺陷更易因其在加热炉内的高温氧化,造成组织氧化脱碳,从而会引起轧制段的严重不均匀变形。